Hinkley 48" CHET Manual page 9

HANGING THE FAN (continued)
1
Slip the yoke cover, trim ring and canopy onto the downrod.
(Fig. 3)
Slide the hanger ball onto the downrod, insert the cross pin
2
through the downrod and tighten. Tighten the set screw.
NOTE:
Fan has 6 feet of hook-up wire in case you
are using a long extension downrod.
Lift ball/downrod/fan into hanger bracket opening.
3
NOTE: The tab opposite hanger bracket opening should fit
in slot on ball. (Fig. 4)
INSTALLATION OF SAFETY CABLE SUPPORT:
Attach the wood screw and the flat washer to the ceiling joist
as shown (do not fully tighten). Slide the cable clamp onto the
safety cable from the fan. Loop the safety cable around the wood
screw that was just attached to ceiling joist. Feed the end of the
cable into the clamp and pull as much cable through as possible.
Firmly tighten screw in the clamp. Cut off excess cable.
Hanger Ball
Downrod
Reverse Switch
Top of Fan Body
Figure 3
Registration Slot
Figure 4
Wood Ceiling Joist
Safety Cable Clamp
Safety Cable Loop
Wood Screw
And Washer
Safety Cable
Figure 5
©2022 Hinkley Lighting, Inc. hinkley.com
Hook-up (3) Wires
Cross Pin
Ground Wire
Set Screw
Canopy
Trim Ring
Yoke Cover
7