Installing The Wall Control - Hinkley SWELL Instruction Manual

INSTALLING THE WALL CONTROL

REMEMBER to turn o° the power before you begin.
NOTE - Secures to any surface or application: flat wall, single gang
box, multi gang box.
Option 1. Flat Surface Installation
Select a desired location. Use the wall plate to mark the
1
location of the mounting holes. Plastic wall anchors or
mounting screws are needed for this application.
Seat the cradle B into the wall plate. Secure the wall plate to
2
the wall using the provided hardware.
3 Snap the face plate cover onto the wall bracket.
Remote transmitter will be held in place with built in magnets.
4
Wall plate
Plastic
anchor
Wall
Fig. 1
HIRO Control System
| hinkle y.c om
12
(Fig. 1)
Cradle B
Face plate
Transmitter
Option 2. For single gang box
Remove the existing wall plate and the old switch from the
1
wall outlet box.
2 Seat the cradle A into the wall plate.
Connect the black lead wires from the switch in the cradle A
3
to the black wires in the switch box. Hot input wire to one of
the cradle A switch leads. Power lead to the fan is connected
to the remaining switch lead.
Connect the wall plate / cradle A assembly to the wall outlet
4
box using the supplied hardware.
Snap the face plate cover onto the wall bracket.
5
Remote transmitter will be held in place with built in magnets.
6
Outlet box
Wall plate
Fig. 2
(Fig. 2)
Cradle A
Face plate
Transmitter