Programmable Alarms - ACU-RITE 06086 Instruction Manual

Programmable Alarms

This display features programmable alarms that sound an alert to notify you when a
value (for outdoor temperature, humidity, wind speed or rainfall) has been reached
or exceeded. When an alarm is triggered, the display emits an audible beep and
flashes data in the affected category.
or OFF the alarms you'd like activated or deactivated, and by inputting your own
values to trigger the alarm.
Setup an Alarm
1. Press and release the "
an alarm is shown on the display. "
2. Press and release the "
3. Press and release the "
display.
4. Press and release the "
5. Press and release the "
6. Press and release the "
Disable an Alarm
1. Press and release the "
disable an alarm is shown on the display. "
2. Press and release the "
3. Press and release the "
4. Repeat steps 1-3, as needed.
NOTE: To disable ALL alarms at once, press and HOLD the "
You will automatically exit alarm SET MODE if no buttons are pressed for 10
seconds. Enter alarm SET MODE at any time by pressing the "
You can customize the alarms by turning ON
" button until the reading for which you wish to set
" will be shown.
" or " " buttons until "
" button. The current alarm value will flash on the
" or " " buttons to adjust the alarm's value.
" button to save the alarm value.
" button to cycle to the next reading.
" button until the reading for which you wish to
" or " " buttons until "
" button to cycle to the next reading.
12
" appears.
" will be shown.
" appears.
" button for 10 seconds.
" button.