ACU-RITE 06086 Instruction Manual page 27

1
PACKAGE CONTENTS
1. AcuRite Access
2. Ethernet cable
3. AC power adapter
1
3
CONNECT
Connect Ethernet cable to your
network router.*
6
WAIT
WAIT
After starting the
Access, the device will
connect to My AcuRite
and download available
firmware updates. It may
take up to 30 minutes.
When Network Status
Light stops flashing (is
solid), you are READY for
the next step.
BLUE LIGHT
®
4
INSTALL BACKUP
BATTERIES
On the bottom of the Access, remove
the battery cover, then
insert three AA
alkaline batteries.
STEADY
WHAT YOU NEED
TM
(not included)
2
CONNECT ACCESS
Connect the Ethernet cable to the Access
2
3
ID# XXXXXXXXX
model# XXXXXX
FCC XXXXXX
AcuRite.com
7
CREATE YOUR ACCOUNT
Create your account and register your Access at www.myacurite.com.
NOTE: Before the Access will communicate with My AcuRite, a compatible My AcuRite
device must be powered on and in signal range. Once the Access has received a signal from a
compatible device, it may take up to 10 minutes to communicate with the My AcuRite service
and allow you to add your Device ID to your account.
OR
www.MyAcuRite.com
• At least one compatible AcuRite device
• Network router with an available Ethernet port
• "Always-on" internet connection
AcuRite
Access
WRITE DOWN THE Device ID;
printed on the bottom of the device.
You will need this when adding the
Access
5
PLUG IN
Plug in the power adapter. The Access
will take a minute to start up.
POWER
ON
AcuRite
MyAcuRite APP
ID# XXXXXXXXX
model# XXXXXX
FCC XXXXXX
AcuRite.com
to myacurite.com.
DEVICE ID