Subscribe to Our Youtube Channel
Related Manuals for Clarke METALWORKER CMSSCS
Summary of Contents for Clarke METALWORKER CMSSCS
- Page 1 METAL SHRINKER/STRETCHER SET MODEL NO: CMSSCS PART NO: 7610950 USER INSTRUCTIONS ORIGINAL INSTRUCTIONS GC06/23-Rev 1...
- Page 2 INSTRUCTION BOOKLET To protect against injury observe the following precautions when using this product. Clarke International is not responsible for misuse of the equipment. • ALWAYS secure the tool in a bench vice before use. • ALWAYS keep the work area free of obstructions.
- Page 3 ASSEMBLY The shrinker/stretcher set just requires final assembly by installing one lever into each tool body and securing with the pre- installed M5 setscrews. Tools required; Hex wrench 3mm MOUNTING The shrinker and stretcher are portable and can be clamped in a vice for use. However, to take full advantage of the set and to get 360 access to your workpiece, you can mount these tools to a stand intended for a bench...
- Page 4 NOTE: Be careful not to lose any springs. 3. Lay out the die components as shown in Fig 4. 4. Clean grease, metal shavings, and debris off the tool and dies, then lightly oil. NOTE: Never use a wire wheel, buffer, sand blaster, or sandpaper on jaw teeth.
- Page 5 The lever stop bolt (see Figure 6) can be adjusted with a 3mm wrench to allow the clamping lever to stop at the same location each time the lever is pulled down. NOTE: If the metal splits during the shrinking/stretching procedure, it is typically because too much bend is trying to be achieved with just a few heavy pulls of the lever.
- Page 6 COMPONENT PARTS...
- Page 7 COMPONENT PARTS ITEM DESCRIPTION ITEM DESCRIPTION Stretcher body Lower V-block(Shrinker) Fulcrum arm pin Upper jaw (Left-Shrinker) External circlip 10mm Lower jaw (Left-Shrinker) External circlip 12mm Retainer clip (shrinker) Finger bolt M5 Die retainer (shrinker) Pressure arm pin Shrinker body Rivet Cross head screw M4 x 12 Pressure arm Upper V-block (stretcher)
Need help?
Do you have a question about the METALWORKER CMSSCS and is the answer not in the manual?
Questions and answers