Related Manuals for Clarke CHT952
Summary of Contents for Clarke CHT952
- Page 1 ½”TORQUE WRENCH SET MODEL NO: CHT952 PART NO: 1801952 USER INSTRUCTIONS ORIGINAL INSTRUCTIONS GC09/24...
- Page 2 INTRODUCTION Thank you for purchasing this CLARKE Torque Wrench. It should NOT be used for UNDOING nuts, as severe damage could occur. With correct use, this tool will produce an accuracy of plus or minus 4%. You can hear and feel when the desired torque setting has been reached.
- Page 3 Rotate the handle further, clockwise, until the ‘6th’ graduation on the grip is aligned with the centre-line to give a setting of 50 + 6 = 56ft/lb. NOTE: If using the ‘N/m’ scale then each division on the grip graduation is equivalent to 1.36N/m.
- Page 4 • The wrench has been calibrated at the factory order to ensure accurate readings and should not require any re-calibration. The original calibration certificate should be supplied. CONVERSION TABLES Newton Metres Pound/Foot Kilogram Metres Kilogram-force (Nm) (lbf.ft) (kg/m) 1.48 0.203 20.39 2.21 0.305...
Need help?
Do you have a question about the CHT952 and is the answer not in the manual?
Questions and answers