Stihl EVC 200 C Instruction Manual page 10

English
► Use the spark plugs described in this
instruction manual.
► Screw in the spark plug and tighten firmly.
► Press on the spark plug socket firmly.
■ The engine may be damaged if it is refuelled
with petrol that is not suitable.
► Use fresh, good-quality unleaded petrol.
► Note the specifications in this instruction
manual.
4.3 Working
WARNING
■ Exhaust gases are produced when the engine
is running.
Breathing in exhaust gases may result
in poisoning.
► Do not breathe in exhaust gases.
► Work in a well-ventilated place.
► If nausea, headaches, vision problems,
hearing problems or dizziness occur: stop
working and consult a doctor.
■ The engine may be hot after it has been run‐
ning.
This may result in people burning
themselves.
► Wait until the engine has cooled down
before cleaning.
■ If the user is wearing hearing protection and
the engine is running, their perception and
assessment of noise may be limited.
► Work calmly and carefully.
■ Misfires or late ignition may occur if the engine
is switched off while it is running at high
speed.
► Allow the engine to run at minimum speed
for 20 seconds before stopping it.
5 Preparing the Engine for
Operation
5.1 Refuelling the Engine
The engine is approved for unleaded petrol.
Unleaded petrol burns with fewer residues,
reduces deposits on the spark plug and extends
the service life of the exhaust system. The petrol
must meet the following requirements:
– The petrol is fresh, clean and unleaded.
– The octane rating of the petrol is at least 85.
– The maximum ethanol content of the petrol is
10% (E10).
10
5 Preparing the Engine for Operation
STIHL recommends STIHL MotoPlus. This fuel is
virtually free of benzene, sulphur and toxic aro‐
matics.
The tank capacity is 0.9 litres.
CAUTION
■ The engine may be damaged if the correct
petrol is not used.
STIHL recommends always using fresh, good-
quality fuel and never using a 2-stroke mixture
(petrol with an oil additive).
Do not use stale or contaminated petrol.
Avoid contaminating the tank contents with dirt
and water.
Only use approved petrol (not E85).
Change the petrol brand if you hear knocking or
ringing.
► If necessary, contact your specialist dealer;
STIHL recommends STIHL specialist deal‐
ers.
► Stop the engine.
► Place the STIHL machine on a level surface.
► Clean the area around the fuel tank cap with a
damp cloth.
► Turn fuel tank cap (1) anti-clockwise until it
can be removed.
► Remove the fuel tank cap.
► Check the seating of the fuel filter.
► Add the petrol using a suitable funnel so that
none is spilled. Add petrol, stopping at least
15 mm short of the fuel tank brim.
► Place the fuel tank cap on the fuel tank.
► Turn the fuel tank cap clockwise and tighten
firmly by hand.
The fuel tank is sealed.
5.2 Adding Engine Oil
The engine oil lubricates and cools the engine.
CAUTION
■ The engine is delivered without engine oil.
Exceeding or falling below the permissible oil fill‐
ing level can result in damage to the engine.
► The engine must be filled with engine oil
before being used for the first time.
0478-983-9945-A