Homelink Universal Transceiver - Acura RL 2005 Online Reference Owner's Manual

Table of Contents Table of Contents
Main Menu Main Menu

HomeLink Universal Transceiver

The HomeLink Universal
Transceiver built into your vehicle
can be programmed to operate up to
three remote controlled devices
around your home, such as garage
doors, lighting, or home security
systems.
General Information
If you are training HomeLink to
operate a garage door or gate, you
should unplug the motor for that
device during training. Repeatedly
pressing the remote control button
could burn out the motor.
The HomeLink transceiver stores
the code in a permanent memory.
There should be no need to retrain
the transmitter if your vehicle's
battery goes dead or is disconnected.
If your garage door opener was
manufactured before April 1982, you
may not be able to program
HomeLink to operate it.
204
They do not have the safety feature
that causes the motor to stop and
reverse if an obstacle is detected
during closing, increasing the risk of
injury.
HomeLink is a registered
trademark of Johnson Controls .
Important Safety Precautions
Always refer to the operating
instructions and safety information
that came with your garage door
opener or other equipment you
intend to operate with HomeLink. If
you do not have this information,
contact the manufacturer of the
equipment.
For quick and accurate training,
make sure the remote control
transmitter for the device (garage
door, automatic gate, security
system, etc.) has a fresh battery.
Training HomeLink
TM
Before you begin
received your vehicle and have not
trained any of the buttons in
HomeLink before, you should erase
any previously learned codes before
training the first button.
To do this, press and hold the front
and rear buttons on HomeLink for
about 20 seconds, or until the red
indicator flashes. Release the
buttons, then go to step 1.
If you are training the second or
third buttons, go directly to step 1.
− If you just