Transportation, Storage And Disposal - Husqvarna Blastrac 1-8DM Operator's Manual

Fault Number
code
U-t 0x09
F0018 0x10
O-hEAt 0x17
0x0B
F0014
0x0E
F0022
SPI n-F 0x0F
F0027 0x11
0x12
F0007
F0021 -
FAULtY -
For all other failure codes: write down the failure code and serial number of the product.
Stop the product and speak to an approved Husqvarna service agent.
Transportation
WARNING:
transportation. The product is heavy and can
cause injury or damage if it falls or moves
during transportation.
CAUTION:
behind a vehicle.
• Make sure that the power supply is disconnected
before transportation.
• Make sure that the electrical cable and dust extractor
hose are disconnected before transportation.
• Remove the abrasive before transportation.
• The wheels let you move the product shorter
distances. For longer distances, lift the product to
move it or put the product on a vehicle.
• Put some type of protection on the product
during transportation. The protection keeps natural
elements such as rain and snow away from the
product.
2043 - 001 - 07.02.2023
Description
Under temperature.
Faulty thermistor.
Drive internal temperature too
high.
External trip (on digital input 3).
Input phase loss trip.
Spin start failed.
Internal memory fault.
Analog input current out of
range.
Internal drive Fault.
Internal drive Fault.

Transportation, storage and disposal

Be careful during
Do not tow the product
Solution
Trip occurs when ambient temperature is less than -10°C.
The temperature must be raised over -10°C in order to
start the drive.
Speak to an approved Husqvarna service agent.
Drive ambient temperature too high, do a check if ade-
quate cooling air is provided.
E-trip requested on control input terminals. Do a check if
the motor is too hot.
Drive intended for use with a 3 phase supply has lost one
input phase.
Spin start function failed to detect the motor speed.
Speak to an approved Husqvarna service agent.
Speak to an approved Husqvarna service agent.
Speak to an approved Husqvarna service agent.
Speak to an approved Husqvarna service agent.
To move the product
WARNING:
are stationary before you move the product.
WARNING:
steel toe-cap and non-slip sole.
• Push or pull the product by the handle.
To move the product up and down a
ramp
WARNING:
move the product up and down ramps. The
product is heavy and there is a risk of injury
if the product falls or moves too quickly.
WARNING:
slope, always use a winch. Do not walk or
stay below or near the product.
Wait until all moving parts
Use protective boots with
Be very careful when you
For ramps with a steep
23