Transportation, Storage And Disposal - Husqvarna Blastrac 1-10DS Operator's Manual

Problem
The motor does not
start.
The product stops af-
ter a while.
The drive system
does not operate cor-
rectly.
Transportation
WARNING:
transportation. The product is heavy and can
cause injury or damage if it falls or moves
during transportation.
CAUTION:
behind a vehicle.
• Make sure that the power supply is disconnected
before transportation.
• Make sure that the electrical cable and dust extractor
hose are disconnected before transportation.
28
Cause
A phase of the power supply is missing.
A phase of the power supply is incorrect.
The emergency stop button is engaged.
There is no power in the drive system.
The motor protection switch is engaged.
The extension cable is disconnected or dam-
aged.
A component is damaged.
The motor protection switch releases be-
cause of overload.
The motor has a damage.
A safety fuse or a fault current breaker is on.
Cables are damaged.
The drive system is not engaged.
Safety fuse or the drive system motor is
damaged.
The control panel is damaged.
The potentiometer is damaged.

Transportation, storage and disposal

Be careful during
Do not tow the product
Solution
Do a check of the power supply.
Adjust the phase.
Turn the emergency stop button clockwise to
disengage.
Start the drive system, then start the blast
motor.
Start the product again. Do a check of the
power supply.
Connect the extension cable or if it is neces-
sary, replace the extension cable.
Speak to an approved Husqvarna service
agent.
Speak to an approved Husqvarna service
agent.
Do a check of the motor.
Speak to an approved Husqvarna service
agent.
Do a check of the cable and replace if neces-
sary.
Install the quick release pin.
Speak to an approved Husqvarna service
agent.
Speak to an approved Husqvarna service
agent.
Speak to an approved Husqvarna service
agent.
• Remove the abrasive before transportation.
• The wheels let you move the product shorter
distances. For longer distances, lift the product to
move it or put the product on a vehicle.
• Put some type of protection on the product
during transportation. The protection keeps natural
elements such as rain and snow away from the
product.
• Engage the drive system during transportation. Refer
To engage the drive system on page 13 .
to
To set the 1-15DS in transport position
WARNING:
is on a horizontal surface before you lift or
lower the product.
Make sure that the product
2070 - 004 - 06.04.2023