Transportation, Storage And Disposal - Husqvarna Blastrac 2-48DS Operator's Manual

Problem
The product does not
move.
The blast motors do
not start.
The product stops af-
ter a while.
The drive system
does not operate cor-
rectly.
Transportation
WARNING:
transportation. The product is heavy and can
cause injury or damage if it falls or moves
during transportation.
2118 - 001 - 27.06.2023
Cause
The drive speed is too low.
The brush list seals get caught on the floor.
The drive system is damaged or not connec-
ted.
A phase of the power supply is missing.
A phase of the power supply is incorrect.
The emergency stop button is engaged.
There is no power in the drive system.
The motor protection switch is engaged.
The extension cable is disconnected or dam-
aged.
A component is damaged.
The motor protection switch releases be-
cause of overload.
A blast motor has a damage.
A safety fuse or a fault current breaker is on.
Cables are damaged.
The drive system is not engaged.
Safety fuse or the drive system motor is
damaged.
The control panel is damaged.
The potentiometer is damaged.

Transportation, storage and disposal

Be careful during
Solution
Increase the drive speed.
Adjust the height.
Engage the drive system. Do a check of the
drive chain.
Do a check of the power supply.
Adjust the phase sequence.
Turn the emergency stop button clockwise to
disengage.
Start the drive system, then start the blast
motors.
Start the product again. Do a check of the
power supply.
Connect the extension cable or if it is neces-
sary, replace the extension cable.
Speak to an approved Husqvarna service
agent.
Speak to an approved Husqvarna service
agent.
Do a check of the blast motors.
Speak to an approved Husqvarna service
agent.
Do a check of the cable and replace if neces-
sary.
Install the quick release pin.
Speak to an approved Husqvarna service
agent.
Speak to an approved Husqvarna service
agent.
Speak to an approved Husqvarna service
agent.
CAUTION:
behind a vehicle.
• Make sure that the power supply is disconnected
before transportation.
• Make sure that the electrical cable and dust collector
hose are disconnected before transportation.
• Remove the abrasive material before transportation.
Do not tow the product
25