Operation - Husqvarna Blastrac 1-8DM Operator's Manual

Safety devices on the product
WARNING:
instructions that follow before you use the
product.
• Do not use the product if the safety devices are
damaged or does not operate correctly.
• Do a check of the safety devices daily. If your safety
devices are damaged or does not operate correctly,
speak to your Husqvarna service agent.
• Do not make modifications on safety devices
Ammeter
The ammeter shows the blast load onto the surface. The
maximum amperage is shown above the ammeter.
To do a check of the ammeter
Product overview on page 3 for information
Refer to
about where the ammeter is on your product.
1. Start the product. Refer to
page 14 .
2. Wait until the ammeter is in idle position.
3. Stop the product. Refer to
page 16 .
ON/OFF switch
The ON/OFF switch is used to start and stop the
product.
To do a check of the ON/OFF switch
Product overview on page 3 for information
Refer to
about where the ON/OFF switch is on your product.
1. Turn the ON/OFF switch to ON postion.
Introduction
WARNING:
product, you must read and understand the
safety chapter.
To do before you operate the product
1. Read the operator's manual carefully and make sure
that you understand the instructions.
2. Read the operator's manual for the dust extractor
carefully and make sure that you understand the
instructions.
3. If the product is operated in connection with a power
source, make sure that you read and understand the
operator's manual of that power source.
2043 - 001 - 07.02.2023
Read the warning
To start the product on
To stop the product on

Operation

Before you operate the
2. Make sure that the product starts.
3. Turn the ON/OFF switch to OFF position.
4. Make sure that the product stops.
Safety instructions for maintenance
WARNING:
instructions that follow before you use the
product.
• Only do the maintenance as given in this operator's
manual. Let an approved service agent do all other
servicing.
• If the maintenance is not done correctly and
regularly, the risk of injury and damage to the
product increases.
• Clean the product to remove dangerous material
before you do the maintenance.
• Do the maintenance of the product on stable level
ground. Make sure that the product cannot move.
• Do not make modifications to the product.
Modifications that are not approved by the
manufacturer can cause serious injury or death.
• Replace damaged, worn or broken parts.
• Do not use a pressure washer to clean the product.
• Only use lint-free cleaning cloths.
• Always use original accessories and spare parts.
Accessories and spare parts that are not approved
by the manufacturer, can cause serious injury or
death.
• After maintenance, do a check of the vibration level
in the product. If it is not correct, speak to an
approved service agent.
• Let an approved service agent do servicing on the
product regularly.
4. Use personal protective equipment. Refer to
Personal protective equipment on page 6 .
5. Make sure that only approved persons are in the
work area.
6. Do daily maintenance. Refer to
schedule on page 17 .
7. Make sure that the product is assembled correctly
and is not damaged.
8. Make sure that all bolts, screws and nuts are
tightened.
9. Make sure that the blastwheel, feed spout, liners and
sealing are not damaged or worn out. Replace the
parts when 75% of the blade thickness has been
worn away.
10. Make sure that the separator is not damaged.
Read the warning
Maintenance
9