Table of Contents
Advertisement
12.2 Total pump-out at the end of the day
The dishwasher is able to perform an automatic cleaning cycle at the end of the day.
Never switch the dishwasher off with water in the tank; always pump out first.
12.3 Topping up with regenerating salt (for models with softener)
Warning: use specific salt only, do not use cooking sea salt. Salt must be supplied when the led
under the symbol indicated in the left side picture lights up. The salt container has a capacity of
about 1 kg of granulated salt. The container is located on the bottom of the tank and it is fitted
with two caps.
A: screw cap - B: bayonet cap
After extracting the basket, unscrewing cap A and extracting cap B, pour the salt using the
provided funnel. Remove salt residues near the opening, if present, before placing the caps.
Correct procedure to refill the regenerating salt:
- start a tank pump-out,
- refill the regenerating salt,
- fill the tank (FILL)
- restart the tank pump-out
- remove any salt residues from the bottom of the tank, as it may cause corrosion/rust.
This procedure prevents the washing water to enter the salt container (possible damage to the
decalcifier) and that possible residues of salt are left in the tank (risk of corrosion/rust).
Press the pump-out button
flashes and the pump-out and automatic tank cleaning
phase starts. The word "UnLoad" scrolls across the
display. If the Led does not flash, the program has not
been started and the boiler heating element is not on.
When pump-out is complete the appliance switches off
(only 2 dots lit on the display)
29
for about 5", the Led
Advertisement
Table of Contents
