Table of Contents
Advertisement
INSUFFICIENT RINSE
INSUFFICIENT DRYING
STAINED GLASSES AND
CUTLERY
WATER LEFT IN THE TANK
AFTER PUMP-OUT.
Clogged nozzles
Boiler incrusted with
limescale
Inappropriate rinse aid, or it
is not dispensed correctly.
Low rinsing temperature
Inappropriate rinse aid, or it
is not dispensed correctly.
Water hardness superior
than 12°dF or it contains
many dissolved salts.
Rinse aid unsuitable or not
being delivered correctly.
Water hardness above 12°dF
or large amounts of dissolved
salts
Waste tube badly positioned
or partially clogged.
32
- Verify that the nozzles are clean and
that the water softener, if present, is
working correctly.
- Verify that the filter of the tube placed
inside the rinse aid jerrycan is not
clogged.
Verify the rinse aid container and if it is
adequate to the type of mains water.
Verify the boiler set temperature
Restore T Stop ON and/or connect the
machine to hot water.
If the problem is not solved, contact the
After-Sales Service.
Verify the rinse aid container and if it is
adequate to the type of mains water. If
the problem is not solved, contact the
After-Sales Service
Check container of rinse aid and whether
type is suitable for the mains water- If the
problem persists, contact the after-sales
service.
Verify that the tube and drainage are not
clogged and that the drainage is not
positioned too high; see connection
scheme.
Advertisement
Table of Contents
