Table of Contents
Advertisement
12.4 Routine inspection of the spray arm (once a week )
Remove the inferior and superior spray arms. Releasing the retaining element "R" is enough to remove them.
Clean the spray arms with clean flowing water, do not use tools which may cause damages. Reassemble the
spray arms carefully.
R
12.5 Lengthy periods out of use
If the dishwasher is to be out of use for a fairly long period of time, the detergent and rinse aid dispenser
devices must be emptied to prevent crystallisation and damage to the pumps: remove the intake hoses
from the detergent and rinse aid containers and place them in a container of clean water, then perform a
few wash cycles followed by a complete pump-out. Finally, turn off the master switch, close the water
intake valve and leave the hood ajar until the interior is completely dry. The detergent and rinse aid intake
hoses must be put back into the containers when the dishwasher is returned to service, taking care not to
swap them over (red hose = detergent, blue hose = rinse aid).
If "rE9E" appears on the display, it indicates that the
machine is carrying out a resin regeneration cycle, which
lasts approximately 90 seconds. It is normal for the machine
to fill or drain water automatically during this procedure,
even if it is not carrying out a washing cycle.
30
Advertisement
Table of Contents
