Cables - National Instruments NI-6587 Getting Started Manual

Table 6. NI 6587 DDC Signals and NI FlexRIO FPGA Module Signals (Continued)
NI 6587
Signal Name
4
STROBE+
5
STROBE-
DDC CLOCK OUT LVDS+
DDC CLOCK OUT LVDS-
SE_PFI_1
SE_PFI_2
SE_PFI_3
Refer to the NI FlexRIO Help for more information about NI FlexRIO CLIP items,
configuring the NI 6587 with a socketed CLIP, and a list of available socketed CLIP signals.

Cables

Caution
accessories to ensure compliance with the EMC requirements defined in the NI 6587
Specifications. Do not use unshielded cables or accessories unless they are installed
in a shielded enclosure with properly designed and shielded input/output ports and
are connected to the NI 6587 using a shielded cable. If unshielded cables or
accessories are not properly installed and shielded, the EMC specifications for the
NI 6587 are no longer guaranteed.
4
Refer to Figure 8 for more information about configuring LVDS STROBE through the crosspoint
switch.
5
Refer to Figure 8 for more information about configuring LVDS STROBE through the crosspoint
switch.
GPIO Input
GPIO_56_CC
GPIO_26_CC
GPIO_38_CC
GPIO_LVDS
GPIO_56_n_CC
GPIO_26_n_CC
GPIO_38_CC
GPIO_LVDS_n
GPIO_44_n
GPIO_42_n
GPIO_35
You must operate the NI 6587 with shielded cables and shielded
NI FlexRIO FPGA Module
GPIO Output
—
— GPIO_43
GPIO_43_n
GPIO_37_n
GPIO_34_n
GPIO_33_n
NI 6587 Getting Started Guide | © National Instruments | 15
GPIO Direction
GPIO_8_n
GPIO_7_n (as enable)
GPIO_44 (as enable)
GPIO_42 (as enable)
GPIO_35_n (as enable)