Water Piping - Space Heating - IBC HC 15-95 Installation And Operating Instructions Manual

HC SERIES BOILERS HC 13-50, HC 15-95, HC 15-96, HC 20-125, HC 33-160
1.6

WATER PIPING - SPACE HEATING

1.6.1 General Piping Considerations
The HC series boilers include a factory installed, integral Grundfos UP 15/58
heating pump. The pump is designed to provide adequate flow through the boiler
and near boiler piping. The pump is pre wired.
Figure 22: Overview of piping options
Primary/secondary piping or the use of a buffer tank / hydraulic separator is
recommended for maximum flexibility in multi zone/load applications. Piping
loads in parallel is only acceptable in systems where the minimum flow rate is
guaranteed to be higher than the minimum for the boiler and the boilers pump is
adequate to provide the required flow rate and pump head for the system.
There are some important details to consider however, and this section of the
Installation and Operating Manual will walk you through them so you can enjoy a
trouble-free installation.
Table 5
1-19
INSTALLATION