Table of Contents
Advertisement
en Cleaning aid
19 Cleaning aid
The cleaning aid
is a quick alternative for occasion-
ally cleaning the cooking compartment. The cleaning
aid softens dirt by evaporating the soapy water. It is
then easier to remove the dirt.
19.1 Setting the cleaning aid
WARNING ‒ Risk of scalding!
If there is water in the cooking compartment when it is
hot, this may create hot steam.
Never pour water into the cooking compartment
▶
when the cooking compartment is hot.
Note: The oven light does not come on while the clean-
ing aid is running.
Requirement: The cooking compartment must have
cooled down completely.
Remove any accessories from the cooking compart-
1.
ment.
2.
ATTENTION!
Distilled water in the cooking compartment leads to
corrosion.
Do not use distilled water.
▶
Mix 0.4 litres water with a drop of washing-up liquid
and pour into the centre of the cooking compart-
ment floor.
Press "Cleaning" in the menu.
3.
Press
"Cleaning aid".
4.
The duration cannot be changed.
Press
.
5.
a A notification stating that you should carry out the
necessary preparatory work for the cleaning aid ap-
pears on the display.
20 Descaling
Regular descaling
is necessary to ensure that your
appliance continues to operate correctly.
How frequently you need to run the descaling pro-
gramme depends on the water hardness and how
many times you have used the steam-assisted opera-
tions. The appliance indicates when only another 5 or
fewer steam-assisted operations are possible. If you do
not carry out descaling, you can no longer set any op-
eration with steam.
Descaling comprises several steps and takes
approximately 70 - 95 minutes:
¡ Descaling (approx. 55 - 70 minutes)
¡ First rinse cycle (approx. 8 - 12 minutes)
¡ Second rinse cycle (approx. 8 - 12 minutes)
For reasons of hygiene, the descaling programme must
be run in full.
If descaling is interrupted, you can no longer set any
operation. To ensure that the appliance is ready for op-
eration again, carry out 2 rinse cycles.
30
Confirm the message.
6.
a The cleaning aid starts and the duration counts
down.
a Once the cleaning aid has ended, a signal tone
sounds. A message appears on the display confirm-
ing that the operation has finished.
Press
to switch the appliance off.
7.
8.
→ "Cleaning the cooking compartment after using
the cleaning aid", Page 30.
19.2 Cleaning the cooking compartment
after using the cleaning aid
ATTENTION!
The prolonged presence of moisture in the cooking
compartment leads to corrosion.
After using the cleaning assistance, wipe the cook-
▶
ing compartment and allow it to dry completely.
Allow the appliance to cool down.
1.
Wipe out the remaining water in the cooking com-
2.
partment using an absorbent sponge cloth.
Clean the smooth enamel surfaces in the cooking
3.
compartment with a dish cloth or a soft brush. Re-
move stubborn food remnants using a stainless
steel scouring pad.
Remove limescale with a cloth soaked in vinegar,
4.
and wipe this away with clean water.
Dry the cooking compartment with a soft cloth.
5.
To dry the cooking compartment completely, leave
6.
the appliance door open for approx. 1 hour or use
the drying function.
→ "Setting the drying process", Page 31
20.1 Preparing descaling
ATTENTION!
The length of time for which the descaler is left to work
is based on the recommended, liquid descaler. Other
descalers may damage the appliance.
Only use the liquid descaler recommended by us
▶
for the descaling programme.
If descaling solution comes into contact with the control
panel or other delicate surfaces, it will damage them.
Remove descaling solution immediately with water.
▶
Mix the descaling solution:
1.
200 ml liquid descaler
‒
400 ml water
‒
Open the control panel.
2.
Remove the water tank and fill it with descaling solu-
3.
tion.
Once the descaling solution has been poured into
4.
the water tank, slide the tank back in.
Close the control panel.
5.
20.2 Setting the descaling programme
Requirement: → "Preparing descaling", Page 30
Press "Cleaning" in the menu.
1.
Advertisement
Table of Contents
