Table of Contents
Advertisement
RIP FENCE ASSEMBLY
1. Mount the fence Guide Rail (#12E) onto the front
table edge with the two fence bar Nuts and Washers
(#14E, 5E) Fig. 5. Position the bar so that it is parallel
with the table surface, and equal distance out from the
front edge of the table when measured at both left and
right front edges of the table.
2. Slide the Fence Carrier Assembly (#9E) onto the
fence's guide rail. Fig. 6.
3. Slide the Rip Fence (#18E) onto the fence carrier,
and lock it in place by tightening the fence lock Knob
(#7E) which is located on the carrier, opposite side to
the fence. Fig. 6, A.
4. With the front Locking Handle (#10E, Fig. 6,B)
secure the fence on the rail so that it does not
move during the rest of the assembly process. Final
adjustments to the
fence are covered on pages 18 to
20. Information on the re-saw bar is on page 21.
INSTALL THE HAND WHEELS
1. Attach the small Handle (#25B) to the large
Handwheel (#24B) that tilts the table. Then install this
handwheel onto the Gear Shaft (#23B) extending out
from the trunnion at the back of the machine. Fig. 7A.
2. Attach the second small Handle to the Handwheel
(#38C) that has been pre-installed at the upper right
side of the saw frame. This wheel raises and lowers
the blade guard.
INSTALL THE 4" DUST PORT
Mount the 4" Dust Port (#53A) under the table on the
right side of the saw frame with four pan head screws
and flat washers (#51A, 52A) using a Phillips screw
driver.
Fig. 7B.
INSTALL THE LOWER BLADE GUARD
Attach the Blade Guard (#19A) to the front of the
lower door with the Handle and Washer (#17A, 18A).
Slide the guard up to protect the lower guides during
use, and slide the guard down when adjusting the
lower guides is needed. Fig. 8A.
INSTALL THE 90° TABLE STOP
1. Tilt the table to gain access to its underside.
2. Thread the Hex Screw (#9B) and Nut (#8B) to the
bottom of the table in the pre-bored and tapped hole.
Fig. 8B.
Setting the table to 90° to the blade will be
done
later on pages 12 and 13.
ASSEMBLY
A
A
A
11
FIGURE 5
B
FIGURE 6
FIGURE 7
B
FIGURE 8
B
Advertisement
Table of Contents
