Mono-Ped Control System (If Equipped) - Doosan D35S-9 Operation & Maintenance Manual

Operation Section
Steering Knob (If Equipped)
There is a steering knob available for inclusion with
new truck deliveries. This option is solely intended for
slow travel situations when two handed steering is not
possible due to hydraulic operations.
WARNING
Loss of stability can occur when a lift truck steering
wheel is rotated quickly while the truck is in motion.
A steering knob will assist with easy rotation of the
steering wheel, but if a steering knob is improperly
used (e.g., rotating the steering wheel quickly while
the truck is in motion), this can contribute to truck
instability and a tip over. A steering knob is intended
for slow travel maneuverability ONLY.
Mono-Ped Control System
(If Equipped)
The MONO-PED pedal controls the speed and
direction of the lift truck. Pushing on the right side of
the pedal causes the lift truck to move in REVERSE.
The optional reverse lights and optional back-up
alarm will be ON in the REVERSE position. Pushing
on the left side of the pedal causes the lift truck to
move in FORWARD.
The speed of the truck increases as the pedal is
depressed
Forward-Push the left side of the pedal for
FORWARD direction travel.
Neutral-The lift truck should not move when
the Mono-Ped pedal is released.
Reverse-Push the right side of the pedal for
REVERSE direction travel.
Sudden reversal of a loaded lift truck traveling
forward can cause the load to fall or the lift trcuk to
tip.
Stop the loaded lift truck completely, before shifting
to reverse.
Failure to comply could result in peronsal injury.
-102-
WARNING