Table of Contents
Advertisement
2 Safety information
The safety information in this document refers only to an indi-
vidual product. Potentially dangerous conditions can arise in
combination with other plant components, which need to be
considered on the basis of a risk analysis. The operator is re-
sponsible for the production of the risk analysis and for com-
pliance with the resulting precautionary measures and re-
gional safety regulations.
The document contains fundamental safety information that
must be observed during commissioning, operation and main-
tenance. Non-compliance with these instructions may cause:
- Personal hazard due to electrical, mechanical and chemical
effects.
- Hazard to nearby equipment.
- Failure of important functions.
- Hazard to the environment due to the leakage of dangerous
substances.
The safety information does not take into account:
- Unexpected incidents and events, which may occur during
installation, operation and maintenance.
- Local safety regulations which must be adhered to by the
operator and by any additional installation personnel.
Prior to commissioning:
1. Transport and store the product correctly.
2. Do not paint the screws and plastic parts of the product.
3. Carry out installation and commissioning using trained
personnel.
4. Provide adequate training for installation and operating
personnel.
5. Ensure that the contents of the document have been fully
understood by the responsible personnel.
6. Define the areas of responsibility.
7. Observe the safety data sheets.
8. Observe the safety regulations for the media used.
During operation:
9. Keep this document available at the place of use.
10. Observe the safety information.
11. Operate the product in accordance with this document.
12. Operate the product in accordance with the specifications.
13. Maintain the product correctly.
14. Do not carry out any maintenance work and repairs not de-
scribed in this document without consulting the manufac-
turer first.
In cases of uncertainty:
15. Consult the nearest GEMÜ sales office.
www.gemu-group.com
3 Product description
3.1 Construction
1
Item
Name
1
Plug
2
Coil housing
3
Valve body
Seal materials
3.2 Description
The GEMÜ 0326 directly controlled 3/2-way pilot solenoid
valve is designed for mounting to a compact aluminium rail as
a valve battery for mounting in control cabinets or as a valve
manifold near the pneumatic components to be controlled.
The body is made of plastic. The coil is plastic encapsulated.
3.3 Functional description
GEMÜ 0326 is a 3/2-way pilot solenoid valve. GEMÜ 0326 is
designed for mounting to a compact aluminium rail as a valve
battery for mounting in control cabinets or as a valve block
near the pneumatic components to be controlled. Battery rail
for up to 10 valves.
3.3.1 Safety function
The fail-safe state is defined as the state where the solenoid
valve is de-energized and the valve is returned to the CLOSED
position (de-energized).
4 GEMÜ CONEXO
In the corresponding design with CONEXO, this product has
an RFID chip for electronic identification purposes. The posi-
tion of the RFID chip can be seen below. The CONEXO pen
helps read out information stored in the RFID chips. The CON-
EXO app or CONEXO portal is required to view this informa-
tion.
Installing the RFID chip
5 / 19
4 GEMÜ CONEXO
2
3
Materials
PA
Standard: PA 6
M12 connection: Duroplast
(Epoxyd NU463)
ATEX version: PPS
PBT
FPM
GEMÜ 0326
Advertisement
Table of Contents
