Table of Contents
Advertisement
Spray Bar
If the machine does not have enough water (at least up to the spray bar), the pump
will be damaged and the machine will fail. Once the proper amount of water has
reached the low level sensor, just below the spray bar, it will be activated allowing
the machine to function properly.
Plug the power cord into a proper electrical outlet and press green POWER button.
Unlock the lid by pulling the hinge, located on the right side of the lid, towards
yourself and close the lid over the tank to maximize insulation efficiency
Set digital timer and temperature controls.
The OMG-5036FSE utilizes (2) 900 Watt built-in silicone heating elements and is
well insulated. The time required to heat the machine initially will vary between two
(2) and three (3) hours. The unit heats water at approximately fifteen (15) degrees
per hour. After the initial heating period, the temperature will remain constant with
very limited electrical draw. It is important that the lid remain closed when not in use
to minimize heat loss and evaporation.
Main Bath
6
Advertisement
Table of Contents
