Packs; Scba Helmets - Omegasonics OMG-5036FSE Operation & Instruction Manual

 After the cycle has completed, inspect the cylinder. If it is cleaned to your
satisfaction, it can be rinsed.
 If it needs another cycle, submerge the basket again and run for another 3-5
minutes.
 Once completed, remove the basket from the bath and rinse thoroughly.

Packs

 In the ultrasonic bath, preheat 1 part Omega AquaClean with 10 parts clean water to
a temperature of 120˚F to 130˚F.
 Place the pack in the basket. Since the pack will not float, a lid is unnecessary.
 Submerge the basket into the bath and clean for 10 minutes.
 After the cycle has completed, inspect the pack. If it is cleaned to your satisfaction, it
can be rinsed.
 If it needs another cycle, submerge the basket again and run for another 10 minutes.
 Once completed, remove the basket from the bath and rinse thoroughly.
SCBA Masks
 In the ultrasonic bath, preheat 1 part Omega AquaClean with 10 parts clean water to
a temperature of 120˚F to 130˚F.
 Place the mask in the basket and add a lid to the basket to keep the mask from
floating.
 Submerge the basket into the bath and clean for 5 minutes.
 After the cycle has completed, inspect the mask. If it is cleaned to your satisfaction,
it can be rinsed.
 If it needs another cycle, submerge the basket again and run for another 5 minutes.
 Once completed, remove the basket from the bath and rinse thoroughly.
 Please note that if your mask contains electronic modules, they will need to be
removed prior to submerging the mask into the ultrasonic tank. Electronic modules
should never be submerged and should always be wiped down by hand.
13