Charging The Handset Battery - Sanyo CLT-9839 User Manual

Installation
P. BACKUP indicator
CHARGE
INTERCOM
SPEAKER
V.MAIL CALLERS P.BACK UP
Flashes while the telephone is powered by the backup batteries.
Turns off when the backup batteries need to be replaced.
CAUTION
When installing batteries:
To prevent corrosive leakage from batteries, which can cause personal injury
and damage to the unit, observe the following precautions:
• Always use new dry batteries for the backup function. If you use used batteries
or if the batteries are drained, the backup function may not work and you may
not be able to place a call, even though the P.BACKUP indicator is on.
• Match the polarities (+ and – signs) on batteries to the polarities shown inside
the battery case.
• Do not mix new batteries with old or used ones.
• Only use batteries of the same type and brand.
• If the unit is not to be used for an extended period of time, remove the batteries
from the unit.
• Carefully follow the battery manufacturer's instructions for proper use and
disposal.
• DO NOT ALLOW YOUNG CHILDREN TO HANDLE BATTERIES.
Note
When the batteries are discharged, they must be disposed of in a safe manner
that complies with all applicable laws.
P. BACKUP indicator
E10

Charging the handset battery

IMPORTANT
Charge the handset before using the cordless phone for the first time.
Do not attempt to use the handset before charging it for a full 10 hours.
1
Place the handset on the base station and charge it
for 10 hours with the POWER switch set in the OFF
position.
Bidirectional handset
The handset can be placed with the keypad facing
up or down.
2
Remove the handset from the base station.
3
Set the POWER switch to ON.
The language menu appears on the display.
To change the display language to French:
press and then within 7 seconds.
MENU
If you do not change the language,
MANAGER
appears.
The handset is ready for use.
Battery LOW
The display will show when the handset needs recharging. Simply place
the handset in the base station cradle and charge it for 10 hours. It is not necessary to
turn the POWER switch off before each charging, except for the first time.
Note
• The handset battery can be recharged and reused many times.
• Repeated recharging for a shorter period may reduce the battery time.
Battery LOW
• If the handset battery fails (the
being charged for 10 hours, replace it with a new Sanyo cordless telephone battery,
type 3N-600AACL or Sanyo / GE GES-PCF01 (See page E41).
Battery saver mode
The handset saves battery power by going into battery saver mode 45 seconds after
you stop using the handset. In this mode, the display "sleeps" (goes blank), but the
handset still receives calls. When you use the handset again, the display automatically
"wakes up". If it does not, make sure the handset power is on.
POWER
ON OFF
English
Français
SANYO CALL
SANYO
CALL MANAGER
appears on the display) even after
E11