Security Code; Troubleshooting - Sanyo CLT-9839 User Manual

Security code

The security code system prevents other 900-MHz phone users from interfering with
the operation of your unit. Since the security code of this telephone was selected from
1,000,000 different codes, it is virtually impossible to find any other cordless telephone
having the same code as yours. However, if you wish to set your own security code,
follow the steps below.
1
Disconnect the AC adaptor and remove backup battery.
2
Set the POWER switch of the handset to the OFF
position.
3
Press and hold PAGE / INT on the base station and
reconnect the AC adaptor. Release
4
While pressing END on the handset, set the
POWER switch to ON. Release END
5
Press on the handset.
6
Enter the desired 6-digit number (000,000 - 999,999)
using the dialing buttons on the handset.
7
Press on the handset.
MEMO
You hear long beeps from both handset and base station.
Your personal security code is now set.
8
Insert the backup battery.
Steps 4 - 8 must be performed within 90 seconds.
If not, five beeps sound to indicate that you should start again from step 1 .
POWER
ON OFF
.
PAGE / INT
Security code:
.
=Change
999999
MEMO=OK
999999
- confirmed -
E44

Troubleshooting

The phone does not work:
• AC adaptor may not be plugged into wall outlet.
• Handset battery may need recharging (
• Handset may be too far from base station.
The communication range becomes shorter:
• Handset may need recharging.
Incoming calls do not ring on the handset:
• Handset is on the base station.
• Handset may be too far from base station.
• Handset ringer may be OFF. (See page E12).
• Handset POWER switch may be set to OFF.
Callers list and directory do not appear:
• Base station may be in use.
• Handset may be too far from the base.
• May be no AC power to base station.
• You may have a power failure.
• You have not subscribed to Caller ID service.
If the phone still does not work, try resetting the base station and handset:
To reset base station
• Remove the backup batteries. Disconnect and reconnect the AC adaptor.
Then insert the backup batteries.
To reset handset
• Set the POWER switch to OFF and then back to ON.
• Disconnect and then reconnect the handset battery.
Battery LOW
appears in talk mode).
E45