System Menu > Adjust/Maint.
Adjust/Maint.
Adjust printing quality and conduct machine maintenance.
[Menu] key > [
][
] key > [Adjust/Maint.] > [OK] key
[Silent Mode]
Value
[Silent Mode]
[Each Job]
[Color Regist.]
When first installing the machine or moving it to a new location, color drift during printing may occur. Use this
function to correct the color position of each of cyan, magenta and yellow to resolve color drift.
➡
Color Registration Procedure (page 357)
[Image Adjustment]
You can select the one you need from drum refresh, development refresh, laser scan cleaning, and color
adjustment and execute it continuously.
[Drum]
Remove image blur and white dots from the printout. It takes about 1 minute and 20 seconds. The time
required may vary depending on the usage environment.
[DeveloperRefresh]
Adjust the printed image that is too light or incomplete, even though there is enough toner.
[LSU]
Remove vertical white lines from the printout.
[ColorCalibration]
Calibrate the device to ensure correct toner overlapping and consistency with the original tone.
➡
Color Adjustment (page 357)
NOTE
• Drum refresh cannot be performed while printing. Execute drum refresh after the printing is done.
• Waiting time may be longer when the toner is refilled during developer refresh.
• When the correct toner overlapping is not ensured even after performing this color adjustment, refer to the
following:
➡
Color Registration Procedure (page 357)
Set the quiet mode. Set this when the operating noise is disturbing.
Value: [Off], [On]
You can set the quiet mode for each job. Here, set whether to allow the
setting for each job.
Value: [Permit], [Prohibit]
245
Description