Toro Groundsmaster 7200 Installation Instructions Manual page 7

4. Use the following processes depending what
LED light your machine has installed.
A. Console LED light
i. The LED light
the sensor calibrates.
ii. When the LED light turns off and the
sensor beeps once, the sensor is
calibrated.
iii. Turn the ignition key to the O
position.
Figure 11
1. LED light
B. InfoCenter LED light
i. The InfoCenter shows advisory 195,
Slope Sensor Calibrating.
Note:
display screen
the sensor calibrates.
ii. When the InfoCenter shows advisory
196, Slope Sensor Calibrated, the
light no longer blinks, and the alarm
beeps once, turn the ignition key to
the O
FF
(Figure 11):
(Figure 11) blinks as
(Figure 12):
The LED light at the top of the
(Figure 12) blinks as
position.
FF
1. InfoCenter LED light
5. Disconnect the calibration connectors and install
the plug onto the connectors
g321269
1. Calibration connectors
7
Figure 12
(Figure 13).
Figure 13
2. Plug
g321268
g315597