Toro Groundsmaster 7200 Installation Instructions Manual page 5

1. Alarm
2. Console panel
Note:
Installing the light and removing the decal
area is for machines without an InfoCenter only.
12. For machines with no InfoCenter, cut out the
hole in the console decal for the light.
13. Install the light into the top of the console
7).
1. Light
Figure 6
3. Threaded ring
Figure 7
Routing the Wire Harness
1. Route the wire harness under the seat pan and
along the along the existing wire harness in the
cross channel
2. Install the middle connector to the machine wire
harness connector labeled TELEMATICS port or
EXPANSION port
3. Connect the wire harness to the light and the
alarm
Route the harness to the controls along the
machine's existing wire harness.
g320855
(Figure
1. Alarm connector
2. Fuse holder
g320858
3. Calibration connectors
4. Middle connector
4. Use the cable ties to connect the new harness
to the existing machine harness.
5
(Figure 8).
(Figure 8).
(Figure 8).
Figure 8
5. 90° connector
6. Light connector
7. Route the harness under
the seat next to the
existing harness.
g320862