Advertisement
Operation
1. Verify that the tethered control-
ler is connected correctly - the
red light on the controller will
be illuminated.
2. Place the On/Off Switch (Fig-
ure 5A) in the ON ("I") position.
3. Press the blue tooth initializa-
tion button on the Primary
controls (left side).
4. The unit will begin to beep and
turn the lights ON and OFF
every 2 ½ seconds to indicate
that the unit is in synchroniza-
tion mode.
5. Within 20 seconds of pressing
the blue tooth button, press
any button on the remote con-
trol (Figure 7).
NOTE: You will have only 20
!
seconds to perform this last step.
Failure to do so will result in these
steps needing to be followed again.
6. If the synchronization was
successful the LED's will blink
5 times and beep 5 times then
the unit will go to Standby.
This will synchronize the remote
control and the tethered controller.
NOTE: It is possible to syn-
!
chronize up to 5 units to one
remote control.
Figure 7
Battery Replacement
To replace the battery:
1. Slide battery cover open on the
remote control (Figure 7).
2. Install two 1.5 Volt (AAA) bat-
tery in the battery holder.
3. Close the battery cover.
Battery must be recycled or
disposed of properly. Check
with your Local
Authority or Retailer for recycling
advice in your area.
Battery Cover
15
Advertisement
