Advertisement
Installation
tripping or snagging to reduce
the risk of fire, electric shock or
injury to persons.
Install the unit into the roughed
8.
in framing ensuring that the unit
is resting on two framing sills,
one at the front and one at the
back or a level surface.
Level the housing - right to left
9.
and front to back, using the
adjustable feet on the bottom of
the unit.
10. Secure the unit to the perma-
nent framing on either end
through a minimum of two
holes (Figure 4).
Operation Preparation
After the surrounding area has
1.
been dry walled and finished,
remove the media plate from
the unit.
Unwrap the tethered controller
2.
and ensure that the wire is lead
through the opening in the bot-
tom of the unit where the hard
plumbing attaches. (Figure 4)
Locate the tethered controller
3.
so that:
a) it can be easily accessed, if
being used as the main controls,
or
b) it is not obscured by either
bricks, stone or sheet metal so
that the signal that is sent from
the remote control can be easily
picked up.
Initialize the tethered controller
4.
to the remote (see operation
section).
5.
Fill the unit:
• Refill Containers - remove
the fill cap assemblies from
the inlet to the reservoir tanks,
then install the refill containers.
(Figure 8)
NOTE: During initial installa-
!
tion, the Refill Container should
be refilled after the Reservoir
has filled to ensure the max-
imum operating time.
• Hard Plumbed - prime each of
the water reservoirs with 33.5 oz
(1L) of water.
Normal tap water can
!
NOTE:
be used in the Opti-myst
as the tap water is not considered
to be hard water. In the event
your tap water is hard, you may
use softened water or distilled
water with ⅛ tsp. of salt (0.5 mL)
added to the water reservoir. (The
use of additional salt should only
be when you notice that the unit is
not producing mist as expected.)
Install the media plate or logset
6.
accessory on top.
as long
®
11
Advertisement
