Advertisement
Operation
B.
Standby
Puts the unit into standby mode
where control by the tethered con-
troller or remote is possible.
C.
Blue tooth
Required for initializing the remote
together, see initialization instruc-
tions for more detail.
D.
Test Mode
Used for troubleshooting issues
- outlined in detail in the service
manual which can be found on
www.dimplex.com/customer_sup-
port.
E. Flame Intensity Control
Adjusts the intensity of the flame
and smoke effect when the unit has
been activated.
Pressing the
flame effect and pressing the
will increase the flame effect.
NOTE: A few moments will be
!
required between adjustment and a
change to the flame effect.
NOTE: During normal operation
!
it is expected to see some con-
densation of water on the media
plate. This will vary depending on
ambient conditions and should be
considered normal.
!
NOTE: When the water tank is
14
will decrease the
empty, the flame effect shuts OFF
and the LED's will blink.
F. Volume Control
Adjusts the volume of the wood fire
sound effects.
On the unit: Pressing the
will decrease the volume and
pressing the
volume.
On the Remote and Tethered
Controller: Pressing the
turn the volume On and Off.
Remote Control
The tethered controller can be used
in the same manner as the remote
but houses the blue tooth receiver
for communication with the remote.
The tethered controller must be
connected to the unit and On/Off
Switch must be in the 'ON' ( I )
position in order for the remote to
operate.
NOTE: To operate correctly the
!
remote control must be initialized
with the unit.
Remote Control Initialization/
Reprogram
In order for the remote to commu-
nicate with the unit the blue tooth
must be setup, as outlined below:
will increase the
will
www.dimplex.com
Advertisement
