5
Mounting
Before starting to set-up the device, you have to connect
the single components of the weather sensor supplied.
To do this, please proceed as follows:
Step 1:
•
Remove the not yet completely assembled
weather sensor and the anemometer (D) from
the packaging.
Put the anemometer to pipe 2 (F) above the main
•
sensor (E).
•
Please make sure that the notch of the rotary axis
matches with the screw hole.
•
Fasten the anemometer with the screw.
Step 2:
•
Loosen the cover of the rain sensor by slight-
ly turning it clockwise and slide it down.
Loosen the safety strip of the rain sensor and
make sure that the rainfall sensor and the counter
rocker are inserted correctly (see „10.2 Clean-
ing the rain sensor" on page 57). The counter
Mounting
43