Table of Contents
Advertisement
Setting [STARTUP]
Automatically enable/disable the shutter function (shutter: closed/open) when the power is turned on.
1)
Press as to select [SHUTTER SETTING].
2)
Press the <执行> button.
f The [SHUTTER SETTING] screen is displayed.
3)
Press as to select [STARTUP].
4)
Press qw to switch the item.
[OPEN]
[CLOSE]
Setting the shutter synchronization function
The shutter synchronization function is a function to synchronize the shutter operation of the specified projector
to other projectors, and the effect using the shutter function including the fade out/fade in operation can be
synchronized.
To use the shutter synchronization function, it is necessary to connect the projectors targeted for synchronization
in a loop with daisy chain connection using the <串口/多台投影机同步输入> terminal and the <串口/多台投影机
同步输出> terminal. For details of how to connect the projectors, refer to "Connecting example when using the
contrast synchronization function/shutter synchronization function" (x page 47).
1)
Press as to select [SHUTTER SETTING].
2)
Press the <执行> button.
f The [SHUTTER SETTING] screen is displayed.
3)
Press as to select [MULTI PROJECTOR SYNC].
4)
Press the <执行> button.
f The [MULTI PROJECTOR SYNC] screen is displayed.
5)
Press as to select [MODE].
6)
Press qw to switch the item.
f The items will switch each time you press the button.
[OFF]
[MASTER]
[SLAVE]
f When anything other than [OFF] is selected, the diagnostic result is displayed in [LINK STATUS], indicating
if all the projectors including the projectors targeted for synchronization are correctly connected, and if
[MODE] is correctly set.
[LINKED]
[NO LINK]
7)
Press as to select [SHUTTER SYNC].
8)
Press qw to switch the item.
f The items will switch each time you press the button.
116 - ENGLISH
Chapter 4 Settings — [DISPLAY OPTION] menu
The projector goes into projection mode with the shutter function disabled (shutter: opened) when the
power is turned on.
The projector goes into projection mode with the shutter function enabled (shutter: closed) when the
power is turned on.
Select this item when the contrast synchronization function and the shutter synchronization function
are not used.
Select this item when the contrast synchronization function or the shutter synchronization function is
used.
Set this item only on one projector that becomes the synchronization source of the shutter operation
within the linked projectors.
Select this item when the contrast synchronization function or the shutter synchronization function is
used.
Set this item in all the linked projectors excluding the projector set as the [MASTER].
All the projectors are correctly connected, and correctly set. They are in the condition that the contrast
synchronization function or the shutter synchronization function can be used.
The projectors are not correctly connected, or not correctly set. Check the cable connection status
and the projector setting for each projector that is linked.
Advertisement
Table of Contents
