Measures For Preparation; Unpacking; Transporting And Lifting; Storage - Samson 43-8 Mounting And Operating Instructions

4 Measures for preparation

After receiving the shipment, proceed as fol-
lows:
1. Check the scope of delivery. Compare
the shipment received with the delivery
note.
2. Check the shipment for transportation
damage. Report any damage to
SAMSON and the forwarding agent
(refer to delivery note).

4.1 Unpacking

Note
Do not remove the packaging until immedi-
ately before installation.
Proceed as follows to lift and install the de-
vice:
1. Remove the packaging from the device.
2. Dispose of the packaging in accordance
with the valid regulations.

4.2 Transporting and lifting

Due to the low service weight, lifting equip-
ment is not required to transport and lift the
Type 43-8 and Type 43-8 N Temperature
Regulators.
Transport instructions
− Protect the device against external influ-
ences (e.g. impact).
− Protect the device against moisture and
dirt.
EB 2178 EN
Measures for preparation
− Observe the permissible ambient tem-
peratures (see section 3.1).

4.3 Storage

NOTICE
!
Risk of temperature regulator damage due
to improper storage.
− Observe the storage instructions.
− Avoid long storage times.
− Contact SAMSON in case of different
storage conditions or longer storage
times.
Note
We recommend to regularly check the de-
vice and the prevailing storage conditions
during long storage periods.
Storage instructions
− Protect the temperature regulator
against external influences (e.g. im-
pact).
− Protect the device against moisture and
dirt. Store it at a relative humidity of
less than 75 %. In damp spaces, pre-
vent condensation. If necessary, use a
drying agent or heating.
− Make sure that the ambient air is free
of acids or other corrosive media.
− Observe the permissible ambient tem-
peratures (see section 3.1).
− Do not place any objects on the device.
15