Unigas C70N US Manual Of Installation - Use - Maintenance page 13

WARNING: before executing the connections to the gas pipe network, be sure that the manual cutoff valves are
closed.
Packing
Such packages fear moisture and are not suitable for stacking.Packing cases of this type are affected by
humidity and are not suitable for stacking.
The following are placed in each packing case:These packagings are damaged by moisture and the
maximum number of overlapping packagings indicated on the outside of the packaging may not be
exceeded.
Burner body

Head

Train

Gaskets

To get rid of the burner's packing, follow the procedures laid down by current laws on disposal of mate-
rials.
Burners are despatched in cardboard packages whose dimensions are:
1600mm x 1000mm x 920mm (L x P x H).

Transport and storage
If the product must be stored, avoid humid and corrosive places. Observe the temperatures stated in the burner data table at the begin-
ning of this manual.
In case of storage, the burners must be stored inside their packaging, in storerooms protected from the weather. Avoid humid or corro-
sive places and respect the temperatures indicated in the burner data table at the beginning of this manual.
Transport and handling
Warning! the handling operations must be carried out by specialised and trained personnel. if these operations are not
carried out correctly, the residual risk for the burner to overturn and fall down still persists. to move the burner, use means
suitable to support its weight (see paragraph "technical specifications").
Warning! If the mass to be moved does not allow sufficient visibility for the shunter, arrange for a signalman to assist on the
ground. In any case, proceed in accordance with current accident prevention regulations.
Lifting and handling must be carried out with a fork-lift truck of adequate capacity for the mass of the burner, its accessories and packa-
ging, taking care to always check in advance that the spaces necessary for manoeuvring have been prepared. Lift the load after ascer-
taining its stability and proceed to the area where the packaging will be freed, avoiding abrupt manoeuvres and dangerous gradients.
The packages containing the burners must be locked inside the means of transport in such a way as to guarantee the absence of dan-
gerous movements and avoid any possible damage.
Handling the burner
The burner is designed to work positioned according to the picture below. For different installations, please contact the Manufacture.
Warning! Don't lift the burner by the air intake silencer!
PART III: INSTALLATION
PART III: INSTALLATION
13
H
L
P