Powervault Nx1950 Initial Configuration Tasks Wizard - Dell PowerVault NX1950 Installation Manual

The Dell Storage Initialization Wizard performs the following steps
to configure your storage system:
1 Configure a network interface controller (NIC) to communicate
with the storage array.
2 Prompts you to setup the storage array privileged users list.
If you change any of properties in the list below, run the Dell Storage
Initialization Wizard by clicking the Run Dell Storage Initialization
Wizard link from Dell Management Tools in the PowerVault NX1950
Management Console.
• NIC or IP Address used to communicate with Dell|EMC storage arrays
• Administrator user name and password for the storage array
• Storage processor IP address
• Add or remove arrays
NOTE:
Microsoft
NX1950 storage systems be configured in a certain order. For more information,
see the Dell PowerVault NX1950 Systems Cluster Installation Guide on the
documentation website at www.dell.com/ostechsheets.
PowerVault NX1950 Initial Configuration Tasks
Wizard
The PowerVault NX1950 Initial Configuration Tasks Wizard supports
the initial configuration of the PowerVault NX1950 storage system.
NOTE:
The PowerVault NX1950 storage systems must be configured in a
certain order. For more information, see the Dell PowerVault NX1950 Cluster
Systems Installation and Troubleshooting Guide on the documentation website
at www.dell.com/ostechsheets.
®
Cluster Services (MSCS) requires that the PowerVault
Completing the Configuration
25