Care And Maintenance - Sharp FP-J52M Operation Manual

CARE AND MAINTENANCE

To maintain optimum performance of this air purifier, please clean the product including the filter periodically.
Be sure to disconnect the power cord from the wall outlet before performing any maintenance.
BACK PANEL
Back
Panel
NOTE How to clean hard to remove dirt
Back Panel
FILTERS
HEPA Filter
Tag
Deodorizing Filter
SENSORS
Sensitive dust sensor
Sensor filter
Sensor
(Odor / Temperature /
Humidity)
(Pre-filter)
Gently remove dust from the back panel, using a vacuum cleaner
attachment or similar tool.
CAUTION
Do not apply excessive pressure, when scrubbing the back panel.
1. Add a small amount of kitchen detergent to water and soak for about
10 minutes.
2. Rinse off the kitchen detergent with clean water.
3. Completely dry the filter in a well-ventilated area.
Gently remove dust from HEPA Filter and Deodorizing Filter with a
vacuum cleaner attachment or similar tool.
CAUTION
Do not wash in water and dry in the sun.
The filters are fragile, be careful not to apply too much force.
• HEPA Filter
Apply the maintenance only on the side with the tag.
Do not clean the opposite side; otherwise, the filter will be damaged.
• Deodorizing Filter
The maintenance can be applied to the both sides.
Sensor
Always be sure to remove the
power plug from the wall outlet.
1. Remove the Back Panel.
2. Remove the Sensor Filter.
3. If it is very dirty, wash it with water and dry it thoroughly.
Gently remove dust from the sensor,
using a vacuum cleaner attachment or similar tool.
8