Advertisement
CARE AND MAINTENANCE
MAIN UNIT / BACK PANEL ( Pre-Filter )
Wipe with a dry, soft cloth
Back Panel
(Pre-Filter)
Remove the dust gently with a cleaning
tool such as a vacuum cleaner.
HEPA FILTER / DEODORIZING FILTER
Remove the dust on the filters.
HEPA FILTER
Tag
Some odors absorbed by the filters will break down over time, causing additional odors. Depending on usage conditions,
and especially if the Main Unit is used in environments significantly more severe than a normal household, these odors may
become noticeable sooner than expected.
Replace the filter in those cases or if dust is unable to be removed after maintenance.
Plasmacluster Ion Generating Unit
1.
Remove the unit
cover, and pull out the
unit holder.
CAUTION
• Do not clean with anything other than the unit cleaning brush. Doing so could lead to failures in the unit.
• A bent electrode could be cut off and dropped during the cleaning process, but it will not change the performance.
• Do not touch the electrode directly. Doing so could lead to pain/itching.
• Do not transform the electrode section. Doing so can damage it.
• Do not touch the connection terminals. Doing so can damage them.
Maintain only the tagged
surface. Do not clean up the
opposite surface.
The filter is fragile, so be
careful not to apply too
much pressure.
2.
Remove dusts from the
electrode section.
Before cleaning
Electrode Around the base
Always be sure to remove the
power plug from the wall outlet.
NOTE
How to clean hard to remove dirt.
Back Panel
1. Add a small amount of neutral detergent
to water and soak for about 10 minutes.
CAUTION
Do not apply excessive pressure when
scrubbing the back panel.
2. Rinse off the neutral detergent with clean water.
3. Completely dry the filter in a wellventilated area.
Sensor Filter
1. Remove the Back Panel.
2. Remove the sensor filter.
3. If the sensor filter is very dirty, wash it
with water and dry it thoroughly.
CAUTION
Do not wash the filters. Do not expose to sunlight.
(Otherwise these filters may lose efficacy.)
DEODORIZING FILTER
( electrode section )
3.
Unit Cleaning Brush
After
cleaning
4
Sensor
Filter
Both surfaces can be
maintained.
The filter may be broken
if being too much power
is applied on it, so please
handle it with care.
Insert the unit holder
in the Main Unit, and
install the unit cover.
Advertisement
