SERVICE WORK ON THE CHASSIS 11
–
Move the clutch fluid reservoir mounted on the handlebar to a
horizontal position.
–
Remove screws
–
Take off cover
H04933-10
–
Fill bleeding syringe
Syringe (50329050000)
Brake fluid DOT 4 / DOT 5.1 (
–
On the clutch slave cylinder, remove the protection cap and
mount bleeding syringe
the bleeder screw
–
Only loosen bleeder screw
the point where filling is possible.
H04934-10
Info
Clean up overflowed or spilled brake fluid immediately
with water.
Avoid contact between brake fluid and painted parts.
Brake fluid attacks paint.
Only use clean brake fluid from a sealed container.
–
Now inject the liquid into the system until it emerges from drill
6
hole
of the master cylinder without bubbles.
–
Now and then, extract fluid from the master cylinder reservoir
to prevent overflow.
–
Tighten the bleeder screw and remove the bleeding syringe
with the hose. Mount the protection cap.
–
Correct the fluid level of the hydraulic clutch.
Guideline
Fluid level below container
H04932-10
rim
–
Position the cover with the membrane. Mount and tighten the
screws.
1
.
2
3
with membrane
.
4
with the appropriate hydraulic fluid.
p. 144)
4
with appropriate hose piece at
5
.
5
on the clutch slave cylinder to
4 mm (0.16 in)
85