–
Check that spring plate
pad sliding plate
correctly.
W00083-10
–
Insert the new brake linings, insert pin
5
pins
.
Guideline
Mount the outer cotter pins from the front to the rear.
Mount the inner cotter pins from the rear to the front.
Info
Always change the brake linings in pairs.
To make it easier to mount the pin, push the brake
J00009-10
linings against the retainer spring.
Make sure the brake linings and retainer spring are
seated correctly.
–
Position the brake caliper.
–
Mount and tighten screws
Guideline
Screw, front
brake caliper
–
Operate the hand brake lever repeatedly until the brake lin-
ings are in contact with the brake disc and there is a pressure
point.
W00081-10
–
Add brake fluid up to level
Guideline
A
Level
(brake fluid level
below reservoir rim)
Brake fluid DOT 4 / DOT 5.1 (
–
Position cover
–
Mount and tighten screws
Info
Use water to immediately clean up any brake fluid that
has overflowed or spilled.
F03693-10
BRAKE SYSTEM 12
7
in the brake caliper and brake
8
in the brake caliper bracket are seated
6
, and mount cotter
4
.
M8
25 Nm (18.4 lbf ft)
A
.
5 mm (0.2 in)
p. 144)
2
3
with membrane
.
1
.
®
Loctite
243™
91