TP-Link T1600G Series Configuration Manual page 401

Configuring Logical Interfaces
2
Logical Interfaces Configurations
To complete IPv4 interface configuration, follow these steps:
1) Create a Layer 3 interface
2) Configure IPv4 parameters of the created interface
3) View detailed information of the created interface
To complete IPv6 interface configuration, follow these steps:
1) Create a Layer 3 interface
2) Configure IPv6 parameters of the created interface
3) View detailed information of the created interface
2.1 Using the GUI
2.1.1 Creating a Layer 3 Interface
Choose the menu Routing> Interface > Interface Config to load the following page.
Figure 2-1 Creating a Layer 3 Interface
1) In the Creating Interface section, specify an interface ID and configure relevant
parameters for the interface according to your needs. Then click Create.
Interface ID Select an interface type and enter the ID of the interface.
Logical Interfaces Configurations
Configuration Guide 378