Table of Contents
Advertisement
Low Voltage Supply Option
TIP:
As an alternative to high voltage, the operator can be powered by 24VAC. It is
recommended to use Vikings Modular Power Box (part # VNXMPB) as the source.
! Caution:
Always turn off power breakers when working with high voltage. DO NOT
connect the "Power Harness" to the Control Board until the electrical installation is
complete and ready for verification.
Install the "Modular Power Box" at the nearest high voltage source (115V or 230V single
phase) and connect to the controller's Power Harness. Follow local codes or guidelines.
Solar Supply Option
Vikings Solar Package (part # VA-SOCHP) is an efficient and effective solution to
powering the operator with solar energy.
!
Tip:
Solar efficiency can be increased
by activating "Solar Mode" from the
LCD Display. Refer to page 42 for
important details regarding this feature.
For 12V solar panels connect
two in series for 24V
Connect the batteries
+
in series for 24VDC
!
The number of cycles achieved daily is dependent on many factors, including
local solar radiation data and power consumption of the motor and accessories. It is
very important that you consider this when using solar power.
VIKING TECHNICAL SUPPORT 1.800.908.0884
MAXIMUM DISTANCE:
1000 ft. with 10 AWG wire
24V AC
Connect to the Power Harness Green & White wires
Solar Input Battery Input Load Input
+
–
+
–
+
–
12V x 2
24V x 1
–
+
–
ELECTRICAL INSTALLATION
115/230V AC
(See page 48 for package details)
Disconnect the operators
Power Harness and use
the Solar Harness.
1 9
Advertisement
Table of Contents
