Gravely Pro-Stance 36 CARB Owner's/Operator's Manual page 30

5. Move steering levers from forward to
reverse several times to ensure controls
are free. Return steering levers to
neutral position.
6. Check wheel(s) for movement.
NOTICE: The right and left hydraulic pumps
are adjusted using the same procedure.
7. If a wheel moves, adjust the return-to-
neutral mechanism on the hydraulic
pump:
a. Loosen the return to neutral screw
on the pump.
b. Slowly move the speed and
direction control bracket clockwise
or counterclockwise until the
wheel stops moving.
c. Hold the stop bracket in position
and tighten the return to neutral
screw on the pump.
8. Move steering levers from forward to
reverse several times and return
steering levers to neutral position.
Check wheel(s) for movement.
9. If wheel is still moving, repeat steps 7
and 8.
10. Shut off engine.
11. Replace drive wheels.
Axle Direction
1. Return-to-neutral Adjusting Screw
2. Speed and Direction Control Arm
Figure 20
STEERING LEVER ADJUSTMENT
(Figure 21)
1. Stop engine and remove ignition key.
Chock wheels to prevent unit from
rolling.
2. Release parking brake.
3. Place rear access panel in the service
4. Loosen jam nuts at top of steering
5. Push and hold a steering control lever
6. Repeat step 5 on other side.
7. Return the steering levers to the neutral
8. If necessary, slightly adjust the control
9. Tighten the jam nuts.
NOTICE: Adjust steering lever interlock if the
steering levers are shifted during application
of the brake. (see Steering Lever Interlock
Adjustment on page 31)
1
2
1. Steering Lever
2. Front Index Bar
3. Steering Control Rod
4. Jam Nut
EN - 30
position (see Service Access on
page 23).
control rod.
forward and turn the control rod until the
steering lever just makes contact with
the front index bar.
position.
rods so the steering levers are aligned
with each other
Figure 21
1
2
4
3