Table of Contents
Advertisement
HOUR METER
Measures and displays (1) the amount of time
engine has been run, time spent on jobs and
service intervals. This time cannot be
cleared.
Operation
2
The hour meter has three functions:
1. Timer (TMR1)
Measures the time spent on individual jobs.
Press and hold the toggle button to reset the
timer to zero. TMR1 will then start measuring
engine run time until it is reset to zero again.
2. Service Alert
Displays maintenance interval reminders for:
•
Changing engine oil (CHG OIL)
•
Changing the hydraulic oil and filter
(CHG HYD OIL)
•
Servicing the air filter (SRV
AIRFILTER)
The alert starts counting down two hours
before the maintenance is due. The meter
flashes NOW when it reaches the
maintenance time.
Press and hold the toggle button to reset the
maintenance clock to zero after performing
the service.
3. Service Interval Presets
Hour meter is preset for recommended
service intervals.
Hydraulic oil and filter:
•
First 75 hours, every 400 hours
thereafter.
Engine oil and filter:
•
First 25 hours, every 100 hours
thereafter
NOTICE: The preset engine oil service
intervals in the hour meter are normal
recommended intervals. Specific engine
manufacturer's recommendations may vary.
Item 14
(
)
Press and
release the
1
toggle button (2)
to shift between
different
functions.
Press and hold
the toggle button
to reset the timer
or clear a service
message.
MOWER LIFT AND HEIGHT-OF-
CUT (HOC) SYSTEM
(Figure 4 and Figure 6)
Deck Lift Pedal (Item 15) and Mower
Lift Lever (Item 16)
Pedal or lever raises and lowers mower deck
for transport or mowing.
Transport Lock Knob (Item 17)
(Figure 5)
When in the lock position, the transport lock
knob allows the deck to automatically lock in
the highest (4.00" or 5.00") HOC position.
NOTICE: When the transport lock knob is in
the lock position (in) the deck will
automatically lock at transport height when
the pedal is pushed fully down or mower lift
lever is pulled fully to the rear.
To raise deck into transport position:
1. Push pedal fully down or pull mower lift
lever fully to the rear.
2. Release pedal or lever.
To lower deck into mowing position:
1. Push pedal or pull mower lift lever to
release pressure on transport lock knob.
2. Pull up on transport lock knob.
3. Release pedal or mower lift lever.
To disable this feature:
1. Move transport lock knob up to the Off
position.
Transport
Lock Off
Height-of-Cut (HOC) Index Wheel
(Item 18)
(Figure 6)
Set cutting height or transport position.
1. Push down on pedal (Item 15) or pull
back on mower lift lever (Item 16) to
release pressure from HOC index wheel
(Item 18).
EN - 15
Transport
Lock On
Figure 5
Advertisement
Table of Contents
