3. View the required default configuration file.
user@host> file show /etc/config/<config file name>
When you commit changes to the configuration, a new configuration file is created, which becomes the
active configuration. If the current active configuration fails, you can use the load factory-default
command to revert to the factory-default configuration.
Initial Configuration Using the CLI
IN THIS SECTION
Connect to the Serial Console Port | 45
Connect to the Mini-USB Console Port | 46
Configure the SRX340 Using the CLI | 47
You can use either the serial or the mini-USB console port on the device.
Connect to the Serial Console Port
To connect to the serial console port:
1. Plug one end of the Ethernet cable into the RJ-45 to DB-9 serial port adapter with your SRX340.
2. Plug the RJ-45 to DB-9 serial port adapter into the serial port on the management device.
3. Connect the other end of the Ethernet cable to the serial console port on the SRX340.
45