Table of Contents
Advertisement
en Troubleshooting
Guide the pull-out rail with the rear retainer
1.
below behind the two guide rods for the required
shelf position and keep it horizontal.
Guide the rail lengthways to the rear to the guide
2.
rods, and slide both retainers onto each lower rod.
In doing so, use the rear retainer
tical rod.
25 Troubleshooting
You can rectify minor faults on your appliance yourself.
Read the troubleshooting information before contacting
after-sales service. This will avoid unnecessary costs.
WARNING ‒ Risk of injury!
Improper repairs are dangerous.
Repairs to the appliance should only be carried out
▶
by trained specialist staff.
If the appliance is defective, call Customer Service.
▶
→ "Customer Service", Page 41
25.1 Malfunctions
Fault
The appliance is not
working.
38
to grip the ver-
Cause and troubleshooting
The circuit breaker in the fuse box has tripped.
Check the circuit breaker in the fuse box.
▶
There has been a power cut.
Check whether the lighting in your kitchen or other appliances are working.
▶
from
Press and hold PUSH
3.
inwards
lower rod.
Release the PUSH tab.
4.
a The retainer clicks into place.
Pull the pull-out rail out as far as it will go and slide
5.
it back in.
Note:
Further information:
WARNING ‒ Risk of electric shock!
Improper repairs are dangerous.
Repairs to the appliance should only be carried out
▶
by trained specialist staff.
Only use genuine spare parts when repairing the
▶
appliance.
If the power cord of this appliance is damaged, it
▶
must be replaced by trained specialist staff.
and swing the pull-out rail
until the retainer
is attached in the
a
Advertisement
Table of Contents
