Table of Contents
Advertisement
en Troubleshooting
Note:
Further information:
21.4 Attaching the pull-out rail
Note: The pull-out rails only fit on the right or left. Make
sure when you fit them that you can pull them out to-
wards the front.
Guide the pull-out rail with the rear retainer
1.
below behind the two guide rods for the required
shelf position and keep it horizontal.
Guide the rail lengthways to the rear to the guide
2.
rods, and slide both retainers onto each lower rod.
In doing so, use the rear retainer
tical rod.
Troubleshooting
22 Troubleshooting
You can rectify minor faults on your appliance yourself.
Read the troubleshooting information before contacting
after-sales service. This will avoid unnecessary costs.
WARNING ‒ Risk of injury!
Improper repairs are dangerous.
Repairs to the appliance should only be carried out
▶
by trained specialist staff.
If the appliance is defective, call Customer Service.
▶
→ "Customer Service", Page 30
28
3.
from
4.
a The retainer clicks into place.
5.
to grip the ver-
Note:
Further information:
Improper repairs are dangerous.
▶
▶
▶
Press and hold PUSH
inwards
until the retainer
lower rod.
a
Release the PUSH tab.
Pull the pull-out rail out as far as it will go and slide
it back in.
WARNING ‒ Risk of electric shock!
Repairs to the appliance should only be carried out
by trained specialist staff.
Only use genuine spare parts when repairing the
appliance.
If the power cord of this appliance is damaged, it
must be replaced by trained specialist staff.
and swing the pull-out rail
is attached in the
Advertisement
Table of Contents
