Hilti DX 6 Manual page 32

3.4 Intended use
The product described is a fastening tool for use in applications in which hardened nails, studs and fasteners
are driven into concrete, steel and sand-lime block.
Use the product only in combination with the equipment designed for use with the fastening tool. Fastener
guides, pistons and fasteners must be compatible with one another.
Use the product only with spare parts and accessories from Hilti and with cartridges and fasteners from
Hilti, or other suitable cartridges and fasteners.
3.5 Bluetooth
®
The Bluetooth word mark and logos are registered trademarks owned by Bluetooth SIG, Inc and any use
®
of such marks by Hilti Corporation is under license.
Bluetooth is a wireless data transfer system by which the two Bluetooth-enabled products can communicate
with each other over a short distance.
This product has a Bluetooth Low Energy module. The module enables communication and data transfers
between smart phones and Hilti gateway. The module is used for checking the status of the product and can
submit data attributes such as location of the receiving device, runtime, total application count, application
count during interval and timestamp of transfer.
Information about the connectivity functions offered can be found in the respective Hilti application
(app).
3.5.1 Data transmission via Bluetooth
The data transmission interval can vary, depending on the available power source of the product. The signal
range can vary greatly depending on external conditions, including the receiving device used. The Bluetooth
range can be significantly less inside closed rooms and through metallic barriers (e g. walls, shelving units,
cases, etc.). Depending on ambient conditions, several transmission intervals may be required before the
product is detected.
If the product is not detected, check the following:
• Is the distance to the mobile terminal device too great?
→ Reduce the distance between the mobile terminal device and the product.
3.5.2 Installing and setting up the app
In order to be able to use the connectivity functions, you first have to install the respective Hilti app.
(1.) Download the app from the corresponding app store (Apple App Store, Google Play Store).
You will require a user account on the corresponding app store to do this.
(2.) When you start the app for the first time, either log in with your account or register.
(3.) The display of your mobile terminal device will show you all the subsequent steps required to connect
the product to the mobile device.
24 English
Release button for fastener guide (A)
The button unlocks the fastener guide (single-fastener tool and mag-
azine) so that the fastener guide can be changed or the fastening
tool cleaned.
Release button for magazine shutter (B)
The button unlocks the magazine shutter so that fasteners can be
inserted.
2232121
*2232121*