Removing The Fold-Enhancing Hp Sensor (Ps3) - Canon Unit-L1 Service Manual

■ Handling after Parts Replacement
1. Execute the tab length adjustment of Z-fold in the following service mode.
on page 79
• Tab length adjustment of Z-fold:
SORTER> ADJUST>PF-T-EDG
2. Execute the adjustment of the folding position in the following service mode.
on page 78
• Adjustment of the fold position of A3 paper Z-fold:
SORTER> ADJUST> PF-A3Z1
• Adjustment of the fold position of B4 paper Z-fold:
SORTER> ADJUST> PF-B4Z1
• Adjustment of the fold position of A4R paper Z-fold:
SORTER> ADJUST> PF-A4Z1
• Adjustment of the fold position of LDR paper Z-fold:
SORTER> ADJUST> PF-LDRZ1
• Adjustment of the fold position of LGL paper Z-fold:
SORTER> ADJUST> PF-LGLZ1
• Adjustment of the fold position of LTRR paper Z-fold:
SORTER> ADJUST> PFLTRRZ1

Removing the Fold-enhancing HP Sensor (PS3)

■ Preparation
1. Remove this equipment from the host
2. Open the Upper Cover.
3. Remove the Front Cover."Removing the Front Cover" on page 46
4. Remove the Rear Cover."Removing the Rear Cover" on page 45
5. Remove the Fold-enhancing
■ Procedure
1. Remove the Fold-enhancing HP Sensor Unit [1].
• 1 Screw [2]
• 1 Connector [3]
machine."Removing the Paper Folding Unit" on page 33
Unit."Removing the Fold-enhancing Unit" on page 48
[2]
1x
1x
62
4. Parts Replacement and Cleaning
" Adjustment of the Tab Length of Z-fold"
"Adjustment of the Z-fold Position"
[1]
[3]