Canon Unit-L1 Service Manual page 59

6. If the distance at the front side is out of the standard
1. Move the Holder [1] to the front side.
2. Loosen the 2 screws [1] and insert the Lower Rear Cover Support Plate [2] as shown in the figure.
NOTE:
Adjust with the Lower Rear Cover Support Plate (height: 6.0 mm).
3. Tighten the 2 screws [2] while pushing the Adjustment Plate [1] upward.
4. Pull out the Lower Rear Cover Support Plate.
7. Check that it is within the standard. If it is out of the standard, repeat steps 5 and 6.
8. Install the removed parts in reverse order.
9. Execute the following service mode.
• Auto adjustment of the fold-enhancing control values:
SORTER > FUNCTION > PF-MTR
2x
[1]
2x
[1]
4. Parts Replacement and Cleaning
[1]
[2]
[2]
52
[3]